Page 19
BASIC OPERATION
RECORDING
Recording Schedule (TIMER RECORD) Example
Privacy Mask Field
MASK FIELD lets you block a specific portion of a channel you do not want
recorded or shown on the display screen. This can be useful if you need
to conceal a sensitive area being captured by the camera. One contiguous
area can be MASKED within a channel. To use Privacy Mask Field:
1. From the Record menu, click MASK FIELD. The Mask Field menu opens.
2. Choose a channel you wish to apply the Mask Field.
3. Select ON from the SWITCH drop-down menu.
4. Click SETUP. The Mask menu will be replaced by the full-screen camera view
of the desired channel. Using the mouse, click and drag the cursor over the
area you want to conceal. A single click will produce a small black square.
Extend the square by dragging the cursor left, right, up or down as desired.
5. Right-click anywhere on the screen to return to the Mask Field menu.
6. Click APPLY. Click OK in the REMARK window. Click EXIT.
Motion Detect Setup
You can configure motion detection for each channel (Camera) connected to the
DVR. To configure motion detection:
1. From the Main Menu click ADVANCED. Then click MD (Motion Detect).
2. Under STATUS, select ON to enable motion
detection for the desired channel.
3. Under SENSITIVITY, select 1 through 8. The higher the
number, the more sensitive the motion detection.
4. Under MD AREA SETUP, click SETUP. The red motion grid
appears over the selected channel in full screen.
5. Click the blocks in the grid to enable/disable motion detection.
Red=motion detection enabled; Clear=motion detection disabled.
6. Right-click anywhere on the screen to return to the Motion Detection menu.
7. Click EMAIL, then select ON/OFF to turn on e-mail notification.
E-mail must be configured. See manual for details.
8. Click BUZZER to turn audible notification of motion ON/OFF.
9. Click APPLY. Click OK in the confirmation window.
10. Click EXIT in all menus until all windows are closed.
NOTE: You can disable the MD buzzer in the Alarm Setup menu.
When MD is triggered, in the Live View Screen you will see a red【M】
in the Channel with a MD warning. You may also see a【R】if you
set up the channel to record when an alarm is triggered.
You want your system to record continuously on all channels
from 9 AM to 5 PM Monday to Friday. You also want Alarm/
Motion recording from 5 PM to 9 AM. You do not want the system
to record Saturday or Sunday:
1. Open the Schedule menu.
2. Under CHANNEL, select ALL.
3. Click the blue NO RECORD block below the
grid. A checkmark will appear in the block.
4. Under SUN, click blocks 00~23. The blocks will turn blue.
5. Under FROM, select SUN. Under TO
select SAT, and then click COPY.
6. Click the red ALARM block below the grid.
7. Under MON, click blocks 00~08 and blocks
17~23. The blocks will turn red.
8. Under FROM, select MON. Under TO select
TUE, and then click COPY. Repeat for Wednesday,
Thursday, and Friday. Your completed schedule
should the same as the schedule to the right.
9. Click SAVE. Click OK in the confirmation window.
Click EXIT in all menus until all windows are closed.
Recording Schedule
Motion Detect Menu
Motion Detect Grid
(4 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales