First Alert FA848C Manual de usuario

HHaarrddwwiirreedd//WWiirreelleessss SSyysstteemmFFAA884488CCUser GuideN9939 7/00PRELIMINARYPrevious Menu

- 10 -NOT READYPART 1and

- 11 -Turning The System On (cont)Determine which zone or zones are not ready, resolve the problem, andturn the system on normally. If the problem can

- 12 -NOTE: This system can be programmed by the installer for the AUTOSTAYfeature which automatically bypasses interior zones if you arm the systeman

- 13 -Turning The System On (cont)TO TURN THE SYSTEM ON IN INSTANT MODEIn INSTANT mode, all alarm sensors including doors that normally have adelay to

- 14 -† If the Quick Bypass feature has been enabled by the installer, do notenter the user code when unbypassing zones.

- 15 -Turning The System OffWhen you turn the system off, you turn off only the burglar portion of yoursystem; any smoke or heat detectors and panic k

- 16 -User CodesTO ADD OR CHANGE A USER CODEUsers can be added or changed directly at the keypad. Your system canhave up to 64 different user codes, w

- 17 -Miscellaneous CommandsSEND HELP ALERTSYour system can be programmed for 3 separate keypad Send Help alertsthat would send an emergency signal to

- 18 -NOTE: Temporary users (i.e. baby sitters, housekeepers, etc.) should notbe shown the Bypass procedure.

- 19 -Miscellaneous Commands (cont)QUICK EXITRestarts exit delay time if the system is already armed. This allowssomeone to leave after the system has

- 2 -Table Of ContentsQUICK REFERENCE...3INTRODUCTION .

- 20 -Miscellaneous Commands (cont)TO VIEW AUTOARM TIMETo view the autoarm time for the partition to which the keypad is assigned,press: # [52] [u

- 21 -Using a PagerIf programmed, the system can send messages to a pager. The messagesdisplay as follows:ACCT E XXXwhere:"ACCT" = the 4-dig

- 22 -pause is optional and is not required to enter your pager phonenumber.) If the [Code] key was pressed, it counts as one character. Thekeypad wil

- 23 -Testing The SystemSYSTEM TESTIt is recommended that you test your system once a week using thefollowing procedure:NOTE: If your system is monito

- 24 -Recommendations On Smoke DetectorsWith regard to the number and placement of smoke/heat detectors, wesubscribe to the recommendations contained

- 25 -Emergency EvacuationEstablish and regularly practice a plan of escape in the event of fire. Thefollowing steps are recommended by the National F

- 26 -GlossaryAC INDICATOR: Small green power on-off light between the center buttonson the keypad. When lit, the system is running on primary power;

- 27 -Your system supports two entry times, allowing you to have a differentlength of time for different doors.

- 28 -Glossary (cont)EXIT DELAY: The period of time allowed between turning the system onand leaving through a designated exit/entry door before the s

- 29 -Glossary (cont)SILENT CONDITION: Most types of alarms and troubles alert you with thekeypad sounder and the sirens, horns, or speakers located i

- 3 -Quick ReferenceTO TURN SYSTEM ON1. Check to make sure the system is ready, The On/Off (ARM) light will light(Green READY light is lit). 2. Ente

- 30 -FEDERAL COMMUNICATIONS COMMISSION (FCC)STATEMENTThis equipment has been tested to FCC requirements and has been found acceptablefor use. The FCC

- 31 -LIMITATIONS OF THIS ALARM SYSTEMWhile this system is an advanced design security system, it does not offer guaranteedprotection against burglary

- 32 -LIMITATIONS OF THIS ALARM SYSTEM(cont)Alarm warning devices such as sirens, bells or horns may not alert people or wake upsleepers who are locat

LIMITED WARRANTYFirst Alert Professional Security Systems.,. a subsidiary of Pittway Corporation, and Pittway Corporation, its divisions,subsidiaries

- 4 -Quick ReferenceThe following table lists the “Quick Commands” available with this control.Key Description Keypads Comments # 1 Quick Arm - If sy

- 5 -IntroductionCongratulations on your decision to protect your home or business with theOMNI-848 security system. You have chosen a reliable, state

- 6 -System ReferenceZONE DESCRIPTIONSIn the following table, enter a description of the area of protection for eachzone.Example: Zone 1 Windows on N

- 7 -System Reference (cont)SEND-HELP ALERTAll keypads are equipped with emergency-pair keys. In order toactivate the alert, both keys must be pressed

- 8 -System Reference (cont)USER CODE ASSIGNMENTSIn the following table, enter the names of the individuals assigned to eachuser number.User Assigned

- 9 -Turning The System OnIS THE SYSTEM READY?You can turn the burglar portion of your security system on and off. Beforeyou can turn the system on, i