Page 11
PRODUCT OVERVIEW
CAMERA AND POWER CONNECTIONS
Connecting Devices
Splitter -
5 camera
1 Power
Power to DVR
Power
from 120V
DC Converter - 12V
VGA to PC Monitor or TV
BNC to Security Camera Monitor
(Not included)
RJ45 Ethernet to
Router and Internet
Follow this to make device connections. Note, some devices are not
included with this kit. See “What’s in the Box” for included devices.
RCA Audio Out to
Powered Speakers
(Not included)
Back Panel
Connect Mouse &
USB Drive
Smartphone
through Mobile
Internet Setup
(Smartphone Not
included)
Video to DVR
Channels 1-8
Video to Camera
Power to Camera
AV Cable: BNC/DC Power
(1 per Camera)
RCA Audio In
from Audio
Cameras
or Powered
Microphone
(Not included)
Splitter Cable
Installing Cameras
Installing Cable-Safe Mounting Bracket
Decide if the camera is to be wall or ceiling mounted and if cable will be fed
through mounting surface hidden directly behind the bracket or fed through
the side of the bracket so cable is exposed. Mark area where you will drill your
hole. The Cable-Safe Mounting Bracket has three Adjusting Points. 1) Rotates
Bracket 360° relative to mounting surface, 2) Adjusts bracket hinge 180° and 3)
Rotates camera body 360° to level image.
Step 1: Select the position for the camera and drill your hole for the cable. Feed
cable through mounting surface. Mount bracket to surface.
Step 2: Aim camera at target and using Adjusting Points 1 and 2 in tandem
position camera. Tighten Ring and Thumb Screw.
Step 3: Rotate camera body using Adjusting Point 3 to the proper view angle
making sure the Camera Shield is always on top and parallel to the ground so
the image is level in the Live View Screen. See “Camera Orientation” Info box.
Tighten screw.
Step 4: Attach proper length of cable and run from camera to DVR location.
Note: Power cable ends are different. Be sure the correct power connector end
matches “To Camera” or “To DVR”. Tip - Connect cable at camera end before
running cable to verify orientation is correct. Also, see Information box on
“Longer Cable Runs”.
Step 5: Check camera orientation via the Live View screen. Adjust as required.
Screw
Thumb Screw Ring
Slot for
exposed
cable
installation
To DVR To Camera
Verify Cable Orientation
2 1
3
Use First Alert Cameras Only
Use First Alert Power Supply Only
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales