Page 12
Power On/Off
To power the system On/Off, connect the power cable
to the DC 12V port on the rear panel. Press the toggle
switch to the on position in the back of the DVR. At
startup, the system performs a basic system check
and runs an initial loading sequence. After a few
moments, the system loads a live display view.
User Login
Password
ATTENTION: By default, passwords are “123456” on the
system. For security purposes, it is highly recommended to
change passwords on the system using the Configuration
Menu. See “Password” section for details on setting
up passwords. Right click and select Login.
INITIAL SETUP
SYSTEM OPERATION
Main Viewing Screen
User Login Menu
System Start Up
Powering your DVR and Cameras
The power supply included with the DVR is rated for 5 amps. Normally, this is enough to power both the
DVR and supplied cameras. However, using aftermarket cameras or a larger number of cameras may sur-
pass the capability of the power supply, causing the systerm to shut down. Most devices should be marked
with the Amperage rating, but some may be marked by wattage. In this case, Amp usage can be found by
dividing Watts by Volts, or A=W/V. The power supply should be upgraded if it surpasses 80% of its rating
(i.e., 4 amps for a 5 amp power supply), to compensate for momentary spikes in current draw. Note: One Amp equals 1000 milliamps
NOTE: Powering down stops the system. The power LED is still
on. The only way to fully power down the system is by turning the
power off & on with the power switch on the back of the DVR.
If no power switch is present, remove the power cord from power outlet.
Main Menu
Right Click Menu
Clicking the right button of the mouse will launch a drop down
menu. This menu will allow you to access the view display
settings, adjust PTZ cameras, and screen settings. It will also
allow acess to the recordings on the hard-drive and main
menu to access other settings
When using the mouse, use the Right Click Menu to
access several system options, including the System
Setup Menu. Select one of the following options:
• View Layout: Provides a choice of viewing channels on the
monitor
• View 1: Allows viewing of 1 channel
• View 4: Allows viewing of 4 channels
• Color Setting: Adjust video image settings by channel
• Search: Open the Search Menu and
playback recorded video
• Record: Access to manual recording
settings for each channel
• Main Menu: Opens the main system menu
Each camera channel
can be adjusted
individually for
brightness, contrast,
hue, sharpness and saturation. To adjust:
1. Channel: Select the proper channel for adjustment using the
Channel drop down.
2. Brightness, Contrast & Saturation may be adjusted by
placing and clicking the mouse cursor with the appropriate
rectangle. Finer adjustments can be made by clicking the +
and - squares.
3. Repeat process for all channels as desired. Or click DEFAULT,
to return video to the original factory settings.
4. Click SAVE.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales