3
4
Programming Preparation Programming a Passcode
PROGRAMMING PREPARATION
INSTALLING BATTERIES
The digital keypad is powered by 4 AA batteries which
must be installed before you can begin programming
your personal code. For your convenience, we have
provided you with 4 AA batteries. For best results and
depending on use, we recommend replacing the batteries
at least once a year.
1
Locate battery compartment to the right of the
digital keypad.
2
To open the compartment, press rmly on the
battery cover and slide it to the right for removal.
3
Install 4 new AA batteries in the battery
compartment. Make sure they are installed in the
correct direction as marked on the inside of the
battery compartment.
4
Once the batteries are installed properly, replace
the cover by sliding it back on from the left.
PROGRAMMING A PASSCODE
LCD DISPLAY MENU
Your new Digital Firesafe features an LCD display to assist in programming and
operating your safe. A menu of the codes is as follows:
Ready to enter your passcode
Ready to program passcode
Correct passcode entered
Incorrect passcode entered
Batteries (AA) must be replaced
PROGRAMMING A PASSCODE
Use the digital keypad to program your own 3 to 8 digit passcode. You may choose
or change your personal passcode at any time by following these steps:
Open the safe as described in "Open Safe with Passcode
& Key" section on the following page. Press
*
and enter the
factory pre-set Passcode: 1 – 2 – 3 – 4 – # to open the safe
for the rst time or your user programmed Passcode if the
pre-set Passcode has already been changed.
1
Locate the memory button marked on the inside of the door.
2
Using a pen or other blunt tip, quickly push and release the
memory button.
3
After you hear a "beep", the LCD display will read "Code" and
you may begin entering your personal code (from 3 - 8 digits)
followed by the # button.
4
Next you will hear a longer "beep" and the LCD display will
ash the code you entered and disappear, indicating that
your personal code has been successfully programmed and
can now be used to open your safe.
BATTERY
COMPARTMENT
LCD
DISPLAY
MEMORY
BUTTON
BATTERY REMOVAL
IMPORTANT:
If the batteries are removed or fail, the keypad memory will NOT be erased.
OVERRIDE ENTRY TO SAFE
IMPORTANT:
In the event that you forget your passcode, you can obtain a Master Override
Code to gain entry into your safe. Contact our Customer Aairs Department
at 1-800-323-9005 to get instructions on how to obtain this code. It takes
some time to complete your request, therefore it is recommended that this
be done immediately so in the event that you forget your passcode, you
will be prepared to immediately gain access to your safe using your Master
Override Code. (See page 5 for instructions on how to open your safe using
the Master Override Code).
SECURITY LOCKOUT PERIODS
IMPORTANT:
For added security, the safe will automatically "Lockout" entry for 5 minutes after three
attempts to open with an invalid passcode. After three more invalid attempts within this
time period, a one-hour "Lockout" period will begin. During these "Lockout" periods, entry
MUST BE MADE using the emergency override key.
(8 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales