5
6
Opening & Closing Digital Safe Additional Features: Removable Shelves
OPENING SAFE WITH PASSCODE & KEY
OPENING THE SAFE
Once your passcode has been entered into the memory,
the safe can be opened by following these simple steps:
1
Insert one of the Companion Entry Keys (round top)
into the lock cylinder but DO NOT TURN KEY.
2
Press the
*
button on the keypad, followed by the
programmed code (use 1 – 2 – 3 – 4 when opening
the safe for the rst time) and the # button.
3
The LCD display will read "Good" and you will hear a
tone indicating that the safe door is unlocked.
4
To open, turn the Companion Entry Key (round
top) to the RIGHT and turn the handle.
NOTE: You must open the safe door within 3 seconds or the electronic
lock automatically engages.
To program personal passcode, follow steps 1-4 on page 3.
TURN ENTRY KEY TO RIGHT ONLY
IMPORTANT:
Turning it to the left may cause key to become stuck in the cylinder and
may cause damage to the lock.
CLOSING THE SAFE
1
Make sure the key is in the open position.
2
Close the door.
3
The handle will automatically return to the closed position.
4
Turn the key all the way to the left.
5
Remove the key from the lock.
MASTER OVERRIDE CODE USE
The Master Override Code can be obtained from our Consumer Aairs Department.
It can be used to gain entry to your safe in the event that you forget your Passcode.
1
Press the
*
button on the keypad and the LCD displays "Open".
2
Within 10 seconds, enter the 8-digit Master Override Code followed by #.
3
After one minute time delay, LCD displays "Good" along with a melody.
4
Within 4 seconds, turn the key to the right to open the safe.
NOTE: You must open the safe door within 3 seconds or the electronic lock automatically engages.
REMOVABLE SHELVES
ADJUSTABLE & REMOVABLE SHELVES
These models are designed with 5 position adjustable shelves to allow greater
exibility and further accommodate your particular security storage needs.
TO INSTALL:
Your shelf and shelf support clips have been shipped
inside your safe and wrapped for protection from
damage during shipping.
1
Remove shelf and (4) shelf support clips from
protective wrapping.
2
Determine the desired position of your shelf and
note the corresponding support guide slots (2 on
each side of interior walls) that are best suited to
support the shelf in that position.
3
Install the (4) shelf support clips in the same
position on all four support guides.
4
Install shelf into position by placing it inside the
safe (tilting if necessary) at a point above the
desired position.
5
Once inside, lower it into position until resting
on shelf support clips.
ADJUSTABLE & REMOVABLE SHELVES
Simply remove the shelf and reposition the (4) shelf
support clips by sliding them up and out of the support
slots and reinstalling them into the new positions. Then
reinstall shelf as described above.
REMOVING SHELF
IMPORTANT:
If you remove the shelf, it is strongly recommended that you DO NOT DISCARD it.
You may lay the shelf at in the bottom of the safe to assure full exibility in the future.
SUPPORT
GUIDES
(8 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales